Electrical connections
Any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations.
THIS HOB MUST BE EARTHED.
The manufacturer declines any liability should these safety measures not be observed.
This hob is designed to be connected to a 230 V ~ 50 Hz AC electrical supply.
Before switching on, make sure the electricity supply voltage is the same as that indicated on the hob rating plate. The rating plate is located on the bottom of the hob. A copy is attached on the back cover of this book.
The hob is supplied with a 3 core flexible supply cable.
The wires in the mains lead are coloured in accordance with the following code:
Green and Yellow | - Earth |
Blue | - Neutral |
Brown | - Live |
Permanent Connection
In the case of a permanent connection, it is necessary that you install a double pole switch between the hob and the electricity supply (mains), with a minimum gap of 3 mm. between the switch contacts and of a type suitable for the required load in compliance with the current electric regulations.
The switch must not break the yellow and green earth cable at any point.
Ensure that the hob supply cable does not come into contact with surfaces with temperatures higher than 50 deg. C.
Supply cable replacement
The cable used to connect the hob to the electrical supply must comply to the specifications given below.
Min. size |
|
|
Cable/flex | Cable / flex type | Fuse |
0.75 mm2 | H05 | 3 A |
|
|
|
1. Connect the green and yellow (earth) wire to the terminal which is marked with
the letter 'E' or the earth symbol 
or coloured green and yellow. The earth wire should be about 2 cm longer than the neutral and live wires.
2.Connect the blue (neutral) wire to the terminal which is marked with the letter 'N' or coloured black.
3.Connect the brown (live) wire to the terminal which is marked with the letter 'L' or coloured red.
Upon completion there must be no cut, or stray strands of wire present and the cable clamp must be secure over the outer sheath.
10
