Electrolux MT21 manual Manual Line Feed System

4

	Manual Line Feed System
To feed the nylon line	H

1.Press and hold the two latches (H).

2.Gently pull the line until it reaches the line cutter.

3.Release the two latches. Check that the spool is locked in position.

4.If too much line has been fed out, press the two latches and turn the spool anti-clockwise until the line is at the desired length.

To remove spool

1. Press and hold the two latches.

2. Pull spool out of spoolholder (J).

When refitting the spool

1.Keep all areas of the spool and spoolholder clean. Failure to do so may prevent the spool from being

securely located in the spoolholder. Line cutter

2.	Make sure the line is placed through the slot in the
	spoolholder (K).
3.	Place spool into spoolholder and press down into
	place.	J
4.	Check that the spool is correctly fitted by trying
	to remove the spool without depressing the	Cleat	Spool
	latches (K1).
To replace nylon line
Replacement line is available from most Electrolux
Outdoor Products stockists. You can buy it either as		Latches
spool and line complete or as nylon line only.
To replace spool and line complete			Spoolholder
1.	Remove old spool.
2.	Release line from cleat. Unwind approximately
	100mm of line and feed through slot in spoolholder
	(K).		Slot
3.	Re-fit spool into spoolholder. Check that the spool is
	locked in position.
To replace nylon line on spool		K
1.	Take approximately 5 metres of line line and insert
	into one of the line lock holes in the spool (L).
2.	Wind line onto spool in the direction of the arrows on
	the top of the spool. Care should be taken to ensure
	that the line is neatly coiled on the spool (L).
3.	Leave approximately 100mm of line unwound and
	feed through slot in spoolholder (K).
4.	Replace spool into spoolholder.
Ensure spool is correctly fitted.			K1
Remember! Your trimmer is designed to use only
nylon line with a maximum diameter of 1.5mm. Use
only genuine Electrolux Outdoor Products nylon line.
Fault Finding Hints
WARNING! Disconnect from the mains electricity
supply before attempting any maintenance or
adjustment.
1.	Line too short.
	Feed out line.	L
2.	Line broken inside of spoolholder.
	Remove spool and re-thread line.
3.	Line jammed on spool.
	Remove spool and rewind line to remove crossed loops.
4.	Poor performance.
	Ensure the inside of the spoolholder is clean and
	free from debris.
5.	Line snaps continuously.
	Use only tip of nylon line to trim. If symptoms still
	persist, change spool and line.
6.	Line will not pull out.
	Check that line has been released from cleat.
7.	IF FAULT PERSISTS
	Contact Electrolux Outdoor Products Customer	Line lock
	Service. Telephone 01325 300303.
		hole