Installation

1/2“ Conduit

Junction

Box Cover

fixing screws

Figure 5

Figure 6

Wiring to Power Supply

WARNING!

ELECTRICALGROUNDINGINSTRUCTIONS

THISAPPLIANCEISFITTEDWITHANELECTRICALJUNCTIONBOXWITH 3 WIRES, ONE OF WHICH (GREEN/YELLOW) SERVES TO GROUND THE APPLIANCE. TO PROTECT YOU AGAINST ELECTRIC SHOCK, THE GREENANDYELLOWWIREMUSTBECONNECTEDTOTHEGROUNDING WIRE IN YOUR

HOMEELECTRICALSYSTEM,ANDITMUSTUNDERNOCIRCUMSTANCES BE CUT OR REMOVED.

Warning: Turn off power circuit at the service panel before wiring this unit.

1.120 V AC, 15 AMP branch circuit required.

2.Remove the junction box cover, unscrew the 4 screws that fix it to the body of the hood.

3.Install the conduit connector (1/2") in junction box.

4.Run 3 wires; black, white and green (wire gauge per code) in 1/2" conduit from service panel to junction box.

5.Connect black wire from service panel to black or red in junction box, white to white and green to green-yellow.

6.Close junction box cover, with its 4 screws. Check all light bulbs to make sure they are secure in their sockets. Turn power on in service panel. Check lights and blower operation per Care & Use section of this manual. Install filters.

7.Install duct cover as shown in Fig. 6.

8.Fit the filters , see Page 9.

Rear discharge:

A 90° elbow may be installed immediately above the hood. For serviceability, a mounting similar to the straight up discharge shown in Figure 4 should be used.

7

Page 7
Image 7
Electrolux PLHV36W7CC manual Wiring to Power Supply, Rear discharge