33
Connecting to gas supply This appliance is designed to be
installed with an appliance flexible
connection only. Supply piping
should not be less than R
3
/8.
Connection is made to the Rc ½ (½”
B.S.P.) female threaded entry pipe
located just below the ho tplate level
on the rear left hand side of the
appliance. NOTE: ONLY LIQUID
SEALANTS TO BE USED WHEN
INLET GAS PIPE IS FITTED I.E.:
DO NOT USE P.T.F.E. SEALANT
TAPE. Carry out a gas tightness test
after connecting to the gas supply.
The gas bayonet connector must be
fitted in the shaded area indicated in
Fig.2. Take into account that it must
be possible to pull t he appliance
forward sufficiently. Ensure the hose
does not become trapped when
pushing the appliance into position.
IMPORTANT: FLEXIBLE TUBING
USED MUST COMPLY WITH
BS.669 CURRENT EDITION.
LPG Flexible connections must be a
type suitable for L.P.G and capable
of operation up to 50 mbar and carry
a red stripe, band or label.
It is r ecommended that if the
appliance is to be installed with a
flexible supply pipe, a stability
bracket be fitted and is available
from your supplier (see Important
Safety Requirements). These
instructions should be read in
conjunction with any leaflet packed
with the stability bracket.
1. Place the appliance in its
intended position and level
appliance.
Fig.3a.
Fig.3b.
487mm (B)
250mm
100mm
20mm
(A)
(C)