8Setting Control
SETTING WARMER DRAWER CONTROL
The knob shown is typical only.
Warmer Drawer Recommended
Food Settings Chart
Food Item | Setting |
Bacon | HI |
Biscuits | MED |
Casseroles | MED |
Eggs | MED |
Empty Dinner Plates | LO |
Fish, Seafood | MED |
Fried Foods | HI |
Gravies, creams, sauces | MED |
Ham | MED |
Hamburger Patties | HI |
Pancakes, Waffles | HI |
Pastries | MED |
Pies | MED |
Pizza | HI |
Pork Chops | HI |
Potatoes (baked) | HI |
Potatoes (mashed) | MED |
Poultry | HI |
Roasts (Beef, Pork, Lamb) | MED |
Rolls, soft | LO |
Rolls, hard | MED |
Vegetables | MED |
To Set the Thermostat Control
The thermostat control knob is used to select the temperature of the warmer drawer. It is located at the right side of the warmer drawer in the open position. The temperatures are approximate, and are designated by HI, MED and LO. The control can be set to the three settings, or anywhere between.
1.To set the thermostat, push in and turn the knob to the desired setting.
2.For best results, preheat the drawer before adding food. An empty drawer will reach the LO setting in about 8 minutes, the MED setting in about 10 minutes, and the HI setting in about 12 minutes.
3.When done, turn the thermostat control to OFF.
Temperature Selection
Refer to the chart in the side column for recommended settings. If a particular food is not listed, start with the medium setting. If more crispness is desired, remove the lid or aluminum foil.
Most foods can be kept at serving temperatures by using the medium setting.
When a combination of foods are to be kept warm (for instance, a meat with 2 vegetables and rolls), use the high setting.
Refrain from opening the warmer drawer while in use to eliminate loss of heat from the drawer. Open only for adding or removing food.
To Warm Serving Bowls and Plates
Heat bowls and plates on the LO setting. Place empty dishes on the rack to raise them off drawer bottom. To further heat dishes or to heat fine china, check with the manufacturer for maximum heat tolerance.
To Set the Humidity Controller
The humidity controller is located on the inside of the warmer drawer and used to control humidity in the warmer drawer. The humidity control knob can
be set at any position between Moist
(Figure 1) and Crispy
(Figure 2)
position. To set the humidity controller, slightly unscrew the knob, slide the controller to the desired location and screw the knob (closed) in place.
Figure 1 |
| Figure 2 |
|
|
|
