9
PERIODIC MAINTENANCE (continued)
How To Replace Brushroll Belt
Step 1: Lower handle to floor to change belt (FIG.21).
Step 2: Remove the two screws from the top of the hood (FIG.22).
Step 3: Lift hood to remove (FIG.23).
Step 4: Lift right end of brushroll (FIG.24).
Step 5: Remove and discard belt.
Step 6: Place new belt around motor shaft.
Step 7: Place new belt around brushroll pulley.
Step 8:Align left end cap with base. Push end cap securely into place.
Make sure the square on the brushroll cap is in place (FIG.25).
Step 9: Pull right side of brushroll to stretch belt.Secure right end cap
into base.
IMPORTANT
Step 10: Rotate brushroll by hand 2 full rotations to properly
position belt.
Step 11: Place hood back on cleaner.Replace and tighten two screws.
Step 12: Return vacuum to upright position.

FIG. 21

FIG. 22

FIG. 23

FIG. 24

FIG. 25

Edge Kleen™ model shown
(some models only)
Edge Kleen™ model shown (some models only)
Edge Kleen™ model shown
(some models only)
Edge Kleen™ model shown
(some models only)