Elemental Designs eStat 762, eStat 761 manual Description, Configure the Switches, q Installation

displayed when heating is activated 40 percent of the time.

is

to maintain the desired temperature. For example,

v Indicates the room OR floor temperature.

w % of heating time.

The thermostat displays the percentage of heating time required

eStat 761/762

User Guide

Programmable Thermostat

n		p
	Description		Configure the Switches

The elements eStat 761/762 programmable thermostats can be used to control the ambient (room) temperature or the floor temperature, depending on the models. The following models are available:

The eStat thermostat has two switches, located on the upper-left part on the rear of the control module, which are used to set the following options:

eStat 761

This model is designed to control the floor temperature. The temper- ature sensor must be installed in the floor.

eStat 762

This model has two temperature sensors:

•One sensor is integrated in the thermostat to control the ambient temperature.

•The other sensor must be installed in the floor to limit the floor temperature.

nDAY/HOUR/MIN—Set the day and clock settings. o PGM—Program the schedule (programs).

pMODE—Select the operating mode. RETURN—To exit a function.

qTo configure temperature setpoints:

Comfort, Economy and Vacation.

rAdjust the floor temperature limit (eStat 762 only). s —Increase and decrease temperature.

t—Indicates the number of the current program when Automatic mode is enabled.

uCurrent operating mode (auto / manual ). In Auto mode, the

program’s associated setpoint icon is also displayed ().

Early Start

When the Early Start function is enabled (disabled by default), the eStat thermostat calculates the optimum system start time to obtain the desired temperature by the set time. To enable this function:

Position switch #1 down.

Note: When this function is enabled, the system can be activated before the program’s start time.

Temperature Display

By default, the eStat thermostat displays the temperature in °C. If you wish to change to °F:

Position switch #2 up.

Note: When you switch from °C to °F or vice versa, the , and setpoints must be redefined.

qInstallation

nRefer to the installation guide of the power base.

oInsert the tabs at the top of the control module in the slots at the top of the power base.

pSecure the control module using the captive screw underneath the base.

Control module

Power base

Display
% of heating time	1 to 24% 25 to 49% 50 to 74% 75 to 99% 100%

eStat 761/762 400-132-028-A 11/6/07 1/3