Elite 005212-0 Exhaust Manifold Procedure, Intake Manifold Procedure, Cylinder Head Procedure

Standby Generator Sets

Maintenance

MAINTENANCE PERFORMED BY AUTHORIZED SERVICE FACILITIES

Before working on the generator, ensure the fol- lowing:

•The AUTO/OFF/MANUAL switch is in the OFF position.

•The 15A fuse has been removed from the con- trol box.

•The 120VAC supply to the battery charger is switched OFF.

EXHAUST MANIFOLD PROCEDURE

1.If necessary, clean gasket surfaces on exhaust manifold and cylinder head.

2.Install exhaust manifold and exhaust manifold gasket.

3.Install fasteners.

NOTE:

Exhaust manifold fasteners must be tightened in two stages.

4.Tighten fasteners to 20-30 N-m (15-22 lb-ft) dur- ing the first stage.

5.Retighten fasteners to 60-80 N-m (44-59 lb-ft) during the second stage.

‹EVERY THREE MONTHS

1.Check battery condition.

2.Inspect and test fuel system.

3.Check transfer switch.

4.Inspect exhaust system.

5.Check engine ignition system.

6.Check fan belts.

‹ONCE EVERY SIX MONTHS

1.Test Engine Safety Devices (low oil pressure, low coolant level, high coolant temperature).

‹ONCE ANNUALLY

1.Test engine governor; adjust or repair, if needed.

2.Clean, inspect generator.

3.Flush cooling system.

‹FIRST 100 OPERATING HOURS

1.Change engine oil and oil filter. After initial change, service engine oil and filter at 150 operat- ing hours or six months, whichever comes first.

2.Retorque cylinder head.

3.Retorque intake and exhaust manifold.

‹EVERY 500 OPERATING HOURS

1.Service air cleaner.

2.Check starter.

3.Check engine DC alternator.

‹EVERY 800 OPERATING HOURS

1.Retorque cylinder head.

2.Retorque intake and exhaust manifold.

3.Check engine compression.

4.Check valve clearance.

INTAKE MANIFOLD PROCEDURE

1.Clean and inspect the mounting surfaces of the intake manifold and the cylinder head. Both sur- faces must be clean and flat (Figure 10.1).

2.Clean and lightly oil the manifold bolt/stud threads.

3.Install a new lower intake manifold gasket.

4.Position the lower intake manifold to the cylinder head.

5.Install retaining bolts/studs finger tight.

6.Tighten all bolts/studs to specifications in the tightening sequence shown:

•First pass = 7=10 N-m (5-7 lb-ft).

•Final pass = 26-38 N-m (19-28 lb-ft).

Figure 10.1 — Intake Manifold Installation

CYLINDER HEAD PROCEDURE

1.Position head gasket on the block (Figure 10.2).

2.Position cylinder head to cylinder block.

3.Install 10 cylinder head bolts in numerical sequence. Tighten to 70 N-m (52 lb-ft) in sequence. Retighten to 70 N-m (52 lb-ft) in sequence. Then turn all head bolts an additional 90 - 100 degrees in sequence.

10-1

08/05 0 .Rev Maint005