Elite BK2080 owner manual Attaching front and rear stabilizers, Attaching the Spindle Bar

Owner’s Manual

Step 1: Attaching front and rear stabilizers

Attach the Front Stabilizer (No.

23) and the Rear Stabilizer (No.			Fig. 1
10) to the main frame using:
		23
4 – Carriage Bolt (No. 9)	9

Owner’s Manual

Step 2: Attaching the Spindle Bar

Insert the Spindle Bar (No. 38) through the Right Connecting Tube (No. 55) into the main frame, into Left Connecting Tube (No. 24). Put a D Shaper Washer (No. 33) and a Spring Washer (No. 32) on either side of the Spindle Bar and tighten both ends using the Hinge Screws (No. 31).

4	– Arc Washers (No. 11)	11
4	– Domed Nuts (No. 12)		12

Place the Front Stabilizer (No.
23) against the main frame and
be sure the holes line up. Take
two of the Carriage Bolts (No. 9)
	11
and pass them through the tube		12
supports located on the unit.			36
Slip the two Arc Washers (No. 11)				12
over the threaded portions of the					11

carriage bolts. Place the two
		10
Domed Nuts (No. 12) over the
	9
Arc Washers (No. 11) and firmly
tighten down the Domed Nuts
(No. 12) using the wrench provided.

Notice: The Front Stabilizer (No. 23) has wheels for moving your Orbitrek Elite.

Follow the same procedure for attaching rear stabilizer.

2 – “D” Shaped Washers (No. 33)

2 – Spring Washers (No. 32)

2 – Hinge Screws (No. 31)

Insert the Right Hinge Bolt (No. 42) with the Arc Washer (No. 93) through the Pedal Post (No. 19 for the right side).

Put Spring Washer (No. 6) on the bolt, then pass the Right Hinge Bolt (No. 42) through the Crank (No. 91) and secure the bolt with the Right Lock Nut (No. 89).

1 – Right Hinge Bolt (No. 42)

1 – Left Hinge Bolt (No. 1)

2 – Arch Washer (No. 93)

2 – Spring Washer (No. 6)

1 – Right Lock Nut (No. 89)

1 – Left Lock Nut (No. 7)

Repeat this procedure for the left side.

ATTENTION:

																			31
																		32
															33
												38
					36
																19
													55
										91
		33
32
31
																	42
19
																								93
24
																						5
																						89
								6
								83
														6
		Fig. 2
											7
									5
								93
							1
		#1: LEFT			#42: RIGHT
																			CORRECT
																			INCORRECT
																				INCORRECT

4

The Right and Left Hinge Bolt (No. 42 & No. 1) must fully penetrate the nylon ring inside the Connecting Tube (No. 5) and the Right and Left Crank (No. 91 & No. 83). This will ensure the stability and durability of you Orbitrek Elite.

In order to install hinge bolt properly, keep it perfectly straight as the bolt goes through the pedal tubing and the crankshaft. If the hinge bolt is connected to the crankshaft at an angle, damage to both the hinge and the crankshaft may occur.

5