Elite ES700P Protection, LS700P Configuration Examples, One Subwoofer, With Mono System

6. Protection

The LS700P has circuitry to prevent clipping, over current and over excursion.The circuitry does not alter the frequency response as the level changes. At high levels the limiter will limit the gain of the LS700P and hence if the user attempts to set the subwoofer level control at high levels the re- sulting setting will be incorrect.The level control should be set while operating at low levels (under 10 watts). If the level control is set to high due to setting it at high operating levels the input circuit will clip and the dynamics of the bass will be lost.This can happen without audible distortion since the filters will filter out the distortion.

LS700P Configuration Examples

POWER		LS700P	FULL–RANGE
	SUBWOOFER
AMPLIFIER			SPEAKER/s

Output

ONE SUBWOOFER, WITH MONO SYSTEM

config01e-ls700p.eps

Left	Right
FULL–RANGE		FULL–RANGE
SPEAKER		SPEAKER
	POWER	config02e-ls700p.eps
LS700P	AMPLIFIER	LS700P
SUBWOOFER		SUBWOOFER

TWO SUBWOOFERS PER SYSTEM

POWER	LS700P	FULL–RANGE
	SUBWOOFER
AMPLIFIER		SPEAKERS
Left	Left
Right
	Right

config03e-ls700p.eps

élite PROCESSOR

L	MID/	SUB	R	MID/	SUB
INPUT	HI	OUT	INPUT	HI	OUT

POWER

AMPLIFIER

R

AMP IN

L

LS700P

SUBWOOFER

Left

FULL–RANGE SPEAKERS

Right

AMP OUT

config04e-ls700p.eps

ONE SUBWOOFER, WITH STEREO SYSTEM

ONE SUBWOOFER USING ÉLITE PROCESSOR

Note: The LS700P built-in stand mounting adapter can be used with Yorkville SW-Teletube accessory to support our E160 cabinets. The support tube can be adjusted up to it’s full 5-foot 4-inch extension safely as long as the LS700P is not inclined mor than 10° (10-degrees).

WARNING: Larger or heavier cabinets shound not be used!