Elkay ER10*1D installation instructions 98243C 3/06, Installation Instructions, E = Electrical

Models: ER10*1D

1 2
Download 2 pages 32.66 Kb
Page 1
Image 1
ER10*1D

ER10*1D

Installation Instructions

ER10-1D

Refrigeration Package

NOTE: It is important to insure proper ventilation. Allow a minimum clearance of 6 inches (152 mm) in front and 3 inches (76mm) in the rear of the unit. If unit is to be installed in an enclosure, allow the following clearances around unit 1 inch (25mm) each side, 3 inches (76mm) in the rear, 3 inches (76mm) inches above wall.

This chiller has been designed for use with potable water and includes an

o-ring seal on the drain plug. This fitting should be replaced if the unit is to be used with more aggressive fluids.

NOTA: Es importante asegurar ventilación apropiada. Asignar una holgura mínima de 6 pulgadas (152 mm) en frente y 3 pulgadas (76 mm) en la parte trasera de la unidad. Si la unidad va a ser instalada en un recinto, asignar la siguiente holgura alrededor de la unidad: 1 pulgada (25 mm) a cada lado, 3 pulgadas (76 mm) en la parte trasera, 3 pulgadas (76 mm) por encima de la pared.

Este congelador ha sido diseñado para su uso con agua potable e incluye un empaque de anillo sellador en el tapón de drenaje. Se deberá cambiar el accesorio si la unidad será usada con fluidos más agresivos.

NOTE: Il est important de s’assurer d’avoir une bonne ventilation. Laissez au moins 6 pouces (152 mm) devant l’appareil et 3 pouces (76 mm) à l’arrière. Si l’appareil est installé dans une enceinte, laissez les distances suivantes autour de lui : 1 pouce (25 mm) de chaque côté, 3 pouces (76 mm) à l’arrière et au dessus du mur.

Ce refroidisseur est conçu pour l’eau potable et comprend un joint torique d’étanchéité sur la bonde. Ce raccord doit être remplacé si l’appareil utilise des liquides plus agressifs.

LEGEND

A = 3/8" O.D. TUBE WATER OUT

D = TEMPERATURE ADJUSTMENT

TUBO DE 3/8" DE DIÁMETRO EXTERNO DE SALIDA DE AGUA

AJUSTE DE TEMPERATURA

TUBE DE SORTIE D’EAU DE D.E. 3/8"

RÉGLAGE DE TEMPÉRATURE

B = 3/8" O.D. TUBE WATER INLET
E = ELECTRICAL

TUBO DE 3/8" DE DIÁMETRO EXTERNO DE ENTRADA DE AGUA

ELÉCTRICO

TUBE D’ENTRÉE D’EAU DE D.E. 3/8"

ÉLECTRICITÉ

C = 3/8" O.D. TUBE TANK DRAIN

 

TUBO DE 3/8" DE DIÁMETRO EXTERNO DESAGÜE DEL TANQUE

 

TUBE DE D.E. 3/8" DE VIDANGE DU RÉSERVOIR

 

98243C (3/06)

Page 1
Image 1
Elkay ER10*1D installation instructions 98243C 3/06, Installation Instructions, ER10-1D Refrigeration Package