Mounting Your Touchmonitor
NOTE: You will need a 6mm allen socket and torque wrench (Hex) to attach the mounting brackets.
Your panel mount touchmonitor comes with 6 mounting brackets (and 6 screws). You will need 6 brackets to mount your touchmonitor. Two brackets attach to the top and bottom and one on each side.
To mount your touchmonitor to a panel, follow the steps below:
1Prepare the opening in the panel (307mm x 398.2mm/12.08" x 15.68"). See page
2Disassemble the 6 brackets and NEMA frame.
3Verify that your touchmonitor will clear the opening as you attempt to front mount it. The opening will be covered by the bezel flanges.
4Mount the touchmonitor from the front side of the opening in the supporting panel and temporarily secure it.
5From the back of the panel opening, slip the NEMA frame over the rear cover. Attach the 6 brackets into the slots. Use 2 brackets on top and bottom and 1 on each side.
6To secure the touchmonitor, turn the screws clockwise until a firm contact is made with the NEMA frame. To assure a “flat” mount, screws should be tightened
