GB
•If an extension cable is used, it must be suitable for the power; otherwise it can cause overheating of the cable and/ or the plug.
This appliance is suitable neither for commercial use nor for use outdoors.
•Children cannot sense the dangers caused by improper handling of electrical devices. Do not, therefore, let children use household devices, except under supervision.
•Pull out the power plug out of the socket, when the appliance is not in use and also before cleaning.
•Caution! The appliance is on power so long as it is connected to the power circuit.
•Switch off the unit before pulling out the mains plug.
•Never carry the unit by its power cord.
SPECIAL SECURITY ADVICE
•Caution! To prevent overheating never cover fan heater.
•Appliance may be installed in bathroom. Keep appliance away from bathtub, shower, wash basin, etc.
•The unit will become very hot during operation. During operation, only touch the appliance’s switches.
•Keep appliance away from flammable materials such as curtains.
•Keep appliance at least 0.5m from walls and ceilings when mounting the appliance on a wall.
INSTRUCTIONS ON ENVIRONMENT PROTECTION
Do not dispose of this product in the usual household garbage at the end of its life cycle; hand it over at a collection point for the recycling of electrical and electronic appliances. The symbol on the product, the instructions for use or the packing will inform about the methods for disposal.
The materials are recyclable as mentioned in its marking. By recycling, material recycling or other forms of re- utilization of old appliances, you are making an important contribution to protect our environment.
Please inquire at the community administration for the authorized disposal location.
PRIOR TO FIRST USE
•Remove all packaging materials.
•Clean the appliance as described in Cleaning and Care.
Wall mount
GB
• Screw in locking screws (7).
OPERATION
•Plug appliance (1) into an electrical outlet.
•To turn appliance on, turn the mode selection switch (3) to the desired position. The control light (2) will go on.
Power off
Cold air
Lightly heated air
Strongly heated air
•Turn the temperature control (5) to the desired position. The fan heater will only activate itself when the room temperature is lower than the set temperature. If you do not want the fan heater to switch off, turn the temperature control (5) clockwise until it reaches the end.
•To switch off, turn the mode selection switch (3) to position 
.
MAINTENANCE AND CARE
•You must observe the Security advice.
•Unplug and wait until the appliance has completely cooled down.
•Clean the casing with a soft, moistened cloth and mild cleaning detergent.
•Never use abrasive or aggressive cleaning agents.
•Store the appliance in a place inaccessible to children.
TECHNICAL DATA
Operating voltage | : | 230V~ 50Hz |
Power consumption | : | 2200 Watt |
GUARANTEE AND CUSTOMER SERVICE
Before delivery, all our products undertake strong quality control procedures. Should a damage during manufacturing or transport arise, despite all our care, please call our Customer Service department (Tel. +49 6074 6960 144 or 145). Besides his legal rights, the client is entitled to the following Warranty: For the purchased product we are offering a 40 months warranty (see the attached Warranty Card), beginning from the purchase day. During this period, you are entitled to free of charge repairs of all shortages resulted from material or manufacturing errors, by repairs or replacement. Any shortages resulted from product handling and errors by unaware customers, interventions or repairs or installation by unauthorized personnel do not fall under this Warranty.
•Unscrew the locking screws (7) and pull off wall mount (10) from fan heater.
•Position the wall mount (10) on the wall, where the fan heater is to be fixed. Observe the minimum distances as shown on the drawings. The 2 upper drilling holes should be placed about 1.5m above ground. Mark the 3 places for the drilling holes (8) on the wall.
•Drill holes on marked places and insert suitable dowels.
•Caution! Prior to drilling make sure you are not drilling into water pipes or electricity lines.
•Insert suitable screws in the 3 drilling holes (8) and fix the wall mount (10) on the wall.
•Fold in the foldable feet (11). Push the feet (13) into the wall mount’s relevant drilling holes (9) until the feet click into place.
5
elta GmbH |
|
| approved |
63322 Rödermark |
|
6
