59

www.eMachines.com
Troubleshooting
Computer

The computer will not start

■Make sure that the power cord is connected to an ACpower source and your computer
is turned on.
Diskette drive

The diskette drive is not recognized

■Shut down and restart your computer.

You cannot save a file to diskette or you see the message “disk is full or

write-protected”

■Make sure that the write-protection tab on the upper-right corner of the diskette is
down (unprotected).
■Delete unnecessary files on the diskette and try again.
■Make sure that the diskette you are using is IBM-compatible.
■Try a different diskette. Occasionally diskettes are flawed and cannot be read by the
diskette drive.
■Run Error-checking on the diskette.
If errors are detected and corrected, try using the diskette again.

You see a “Access Denied” or “Write protect” error message

■Move the write-protection tab in the upper-right corner of the diskette down
(unprotected).
■The diskette may be full. Delete unnecessary files on the diskette and try again.
■Make sure that the diskette you are using is IBM-compatible.
■Try a different diskette. Occasionally diskettes are flawed and cannot be read by the
diskette drive.

You see a “Disk is full” error message

■Delete unnecessary files on the diskette.
■Try a different diskette. Occasionally diskettes are flawed and cannot be read by the
diskette drive.
■Run Error checking on the diskette.