5DOC.IG.QC01.1 Rev.: B December ‘06
En
+
-
1
2
3
4
5
6
7
8
0.5 A
max.
15VA
max.
24 VDC +/- 15%
0.5 A
max.
15VA
max.
+
-
24 VDC +/- 15%
1
2
3
4
5
6
7
8
0-30 VDC/VAC
0.5 Amax.
15VAmax.
24 VDC +/- 15%
0-30 VDC/VAC
0.5 Amax.
15VAmax.
Control Module
Type Label
Terminals Status LED
2
1
3
4.3 Wiring dimensions
Solid wire : 2.5mm2 max.
Stranded wire : 0.2-3.3mm2 or 24-12 AWG
4.4 Tools
Tool for terminals : Screw driver 0.6 x 3.5
Tool for cover screws : Screw driver for cross
slotted Phillips screws nr. 2
WARNING:
* Do not put the Control Module and the Pneumatic
Module in direct contact with magnetic material.
This can cause damage or malfunction of the
position feedback.
* If the Control Module is used in a manner not
specified by the manufacturer, the protection
provided by the equipment may be impaired.
* If required, mount earth wire (1) between top (2)
and bottom (3) ring of earth wire connection (see
figure 6).
4.5 Procedure
1 Remove Control Module cover (see figure 5).
2 Guide the cable(s) through the electrical
entry(ies).
- Use and mount cable glands as required by
national or local legislation.
- When IP65 / NEMA4X ingress protection is
required, the electrical entries must be fitted
with glands rated IP65 / NEMA4X or higher.
3 Make the electrical connections as shown in
figure 7 or 8.
- For hazardous area connections, see the
instructions in chapter 10 or 11.
4 Mount the Control Module cover to the housing
(see figure 5) or continue with chapter 5. T a ke
care that the cover seal is in place to comply to
dust and water tightness according to
IP65 / NEMA4X.
Field wiring Unit wiring
1-2 Feedback 2
3-4 Feedback 1
5-6 Control supply
voltage
7-8 Power supply
voltage
Field wiring Unit wiring
1-2 Feedback 2,
3-4 Feedback 1
5-6 Control
7-8 Power supply
voltage

Fig.7: QC01 electric connections, seperate

circuits

Fig.8: QC01 electric connections, common “-”

Fig.5: Terminal connections behind cover.

Fig.6 Earth wire connection