22
MODEL 54eA SECTION 5.0
SOFTWARE CONFIGURATION
Program
Calibrate (see page 21)
Diagnostic Variable (see page 21)
Main
Menu
Alarms 1, 2, and 3 setpoints
4 mAor 0 mA
20 mA
Present output current
Alarm Setpoints
Output setpoints
Test output 1 or 2
Test alarm 1, 2, 3, or 4
Simulated tests
Configure
Display Main
Sensor Oxygen
Free Chlorine
Total Chlorine
Monochloramine
Ozone
Outputs Output 1 and 2
control
Measurement: main snr, pH, temp.
Control mode: normal, PID
Output 1 and 2
setup
Range (0-20 or 4-20 mA)
Dampen*
Hold - keep last value
Hold - go to specified value
Fault
Setpoint, proportional, integral
Derivative**
Hold feature setup
*Normal only **PID only
Alarms Alarm 1, 2, & 3
control
Measurement: main snr, pH, temp.
Control mode: normal, TPC
Alarm 1, 2, & 3
setup
Alarm: High, low, or off*
Setpoint
Hysteresis*
Delay*
Time period, URV, LRV**
Relay default
Interval timer Timer: Alarm 1, 2, or 3 or disable
Interval
Repeats
On time
Off time
Recovery time
Alarm 4 setup
Feed limit timer Feed limit: Alarm 1, 2, or 3 or disable
Timeout
*Normal only **TPC only
Continued on page 23FIGURE 5-1. Menu Tree for the 54eA Controller(continued)Sensor type and manufac.
Units: ppm, ppb, % sat
°C or °F
Output 1 (mAor %FS)
Output 2 (mAor %FS)
Language
Line 3 display
Display contrast
Timeout (on or off)
Timeout - limit
Polling address