![](/images/new-backgrounds/1314015/31401519x1.webp)
WAKE TO BUZZER
NOTE: Alarm 1 and Alarm 2 have different buzzer sounds.
•Alarm 1 is a “Single beep” sound.
•Alarm 2 is a “Double beep” sound.
You will be able to tell which alarm is going off by the sound that it makes.
1.) Reconfirm the wake up time and alarm mode settings for the alarm you are using, Alarm 1, Alarm 2, or both alarms.
2.) Set the Alarm selector switch for 1, 2 or Dual position. The appropriate ALM 1 and/or ALM 2 indicators will light up to confirm that the alarms are set.
3.) At the selected wake up time the buzzer will sound. It will continue for one hour and then shut off automatically.
4.) To stop the buzzer sooner, press either the appropriate Alarm 1 or Alarm 2 button. The buzzer will stop but the alarm remains set and will turn the buzzer on again at the same time on the following day (depending on the Alarm Mode setting).
5.) If you do not want the alarm to turn the buzzer on the following day, set the Alarm selector to the “Off” position.
SNOOZE ALARM
After the buzzer alarm sounds in the morning you may press the SNOOZE button for a few more minutes sleep. The respective ALM indicator will flash.
The alarm will stop for approximately 9 minutes and then turn on again. You may repeat the Snooze operation up to seven times if desired, but after the seventh time the alarm will not turn on again.
DIMMER CONTROL
The Dimmer control was set to the High position at our factory. If you find the clock display is too bright in a darkened room, set the Dimmer control to the Low position.
9
AC100_072806.p65 | 9 |
28/7/2006, 10:32