Emerson CF130BS00, CF130WW00, CF130ORB00 How to Hang Your Ceiling Fan For Standard Mounting

BP7404 Tilo 12/16/09 4:06 PM Page 10

How to Hang Your

Ceiling Fan For

Standard Mounting

1. Carefully lift the fan assembly and seat the hanger ball in the hanger bracket (Figure 15). The tab on the hanger bracket must seat in the groove in the hanger ball.

! WARNING

Failure to seat tab in groove could cause damage to electrical wires and possible shock or fire hazard.

! WARNING

To avoid possible fire or shock, do not pinch wires between the hanger ball/downrod assembly and hanger bracket.

HANGER

BRACKET

NOTE: Make all wiring connections using wire connectors (supplied). Make sure that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire.

1. Connect the green grounding lead from the hanger ball and the green grounding lead from the hanger bracket to the grounding conductor of supply (this may be a bare wire or wire with green colored insulation) (Figure 16). Securely connect wires using wire connectors supplied.

NOTE: When wiring the ceiling fan for close-to-the-ceiling mounting, there will be no green grounding lead from the hanger ball.

2. Securely connect the fan motor white wire to the supply white (neutral) wire using wire connector supplied (Figure 16). Securely connect the fan motor black wire and blue wire to the supply black (hot) wire using wire connector supplied (Figure 16). After connections have been made, turn leads upward and carefully push leads into the outlet box, with the white and green leads on one side of the outlet box and the black and blue leads on the other side of the outlet box.

TAB	HANGER
GROOVE	BALL

Figure 15

How to Wire

Your Ceiling Fan

If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician.

! WARNING

Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.

WIRE CONNECTOR

BLACK
SUPPLY (HOT)
	SUPPLY
	GROUND
	WIRE
BLUE	GREEN
	GROUND WIRE
FAN WIRE	FROM HANGER
BLACK	BRACKET
FAN WIRE	GREEN
WHITE SUPPLY
	GROUND
NEUTRAL)
	WIRE FROM
WHITE FAN WIRE
	HANGER BALL

Figure 16

! WARNING

Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.

10 UL Model No.: CF130