BP7404 Tilo 12/16/09 4:06 PM Page 9
!
WARNING
To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked “Acceptable for Fan Support”, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt.
!
WARNING
Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.
NOTE: The hanger bracket must be mounted flush with the ceiling in order for the ceiling cover to install properly. If necessary, use leveling washers (not supplied) between the outlet box and the hanger bracket.
2. Slide the hanger bracket onto the outlet box screws. Center the bracket over the outlet box and then securely tighten the screws (Figure 13).
How to Hang Your Ceiling Fan For Close-
1. For
2. Carefully lift the fan assembly up to the hanger bracket. Pass the hook on the hanger bracket through one of the screw holes (not the slots) in the ceiling cover (Figure 14). The hook must pass from the inside of the ceiling cover to the outside. The hook will hold the fan assembly while connecting the wiring.
!
WARNING
The hook must pass through the screw hole in the ceiling cover from the inside to the outside. Any other hanging method may cause the hook to break and the fan to fall.
3. Loosely install two M5 x 10mm screws and lockwashers (supplied) in hanger bracket at this time. The remaining two lockwashers and screws will be installed after the ceiling fan is hung (Figure 14).
HOOK ON HANGER BRACKET MUST PASS THROUGH SCREW HOLE IN CEILING COVER, INSIDE OF BRACKET TO OUTSIDE OF BRACKET
| SECURELY | |
| TIGHTEN | |
HOOK | SCREWS | |
HANGER | ||
Figure 13 | ||
BRACKET |
!
WARNING
Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, remove wall board until bracket contacts box. If bracket and/or outlet box are not securely attached, the fan could wobble or fall.
HOOK | M5 x 10mm |
| SCREW AND |
| LOCKWASHER |
| (2 each) |
CEILING COVER
FAN
HOUSING
DECORATIVE
UPPER COVER (2)
Figure 14
9 | UL Model No.: CF130 |
