Electrical Requirements
Your new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit.
The outlet box must be securely anchored and capable of withstanding a load of at least 50 pounds.
!
WARNING
To reduce the risk of fire, electrical shock, or personal injury, mount fan to outlet box marked “Acceptable for Fan Support”, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt.
If your fan is to replace an existing ceiling light fixture, turn electricity off at the main fuse box at this time and remove the existing light fixture.
!
WARNING
Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before attempting installation. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.
!
WARNING
To avoid fire or shock, follow all wiring instructions carefully. Any electrical work not described in these instructions should be done or approved by a licensed electrician.
How to Put Your Ceiling Fan Together
1.One by one unscrew each screw and discard screw and shipping retainer (Figure 1).
ADAPTER
PLATE
REMOVE AND DISCARD
THE FIVE SHIPPING
RETAINERS AND SCREWS
FROM THE ADAPTOR
PLATE
Figure 1
2.Mount blade flanges to fan blades using three M5 x 6mm washer head blade screws (Figure 2).
NOTE: Take care not to scratch fan housing when installing blades.
M5 x 6mm WASHER HEAD BLADE SCREW (3 per blade/flange)
FAN BLADE
BLADE FLANGE 
Figure 2
3.Loosely attach one blade/flange assembly to the motor hub by securing the two M6 x 14mm captive pan head screws. Make sure the screws are NOT tightened (Figure 3). Repeat this procedure for other four blade assemblies.
!WARNING
To reduce the risk of personal injury, do not bend the blade flange when installing the blade flanges, balancing the blades or cleaning the fan. Do not insert foreign objects in between rotating fan blades.
4 | U.L. Model No.: CF552 |
