!WARNING
To reduce the risk of personal injury, do not bend the blade flange when installing the blade flanges, balancing the blades or cleaning the fan. Do not insert foreign objects in between rotating fan blades.
RIB LINE (THIS SIDE UP)
M5 x 6mm SLOTTED
PHILLIPS WASHER HEAD
SCREWS (3)
BLADE FLANGE
FAN BLADE
Figure 5 | CAPTIVE PHILLIPS |
FLANGE SCREW |
SWITCH HOUSING ASSEMBLY 
SWITCH HOUSING CONNECTOR
MOTOR CONNECTOR 
SWITCH
HOUSING PLATE 
Figure 7
12.Position the switch housing assembly on the switch housing plate and secure using three captive Phillips flathead screws (Figure 8).
NOTE: Do not pinch wires between the switch housing assembly and the switch housing plate.
SWITCH |
|
HOUSING | CAPTIVE |
ASSEMBLY | PHILLIPS HEAD |
| FLAT SCREW (3) |
8.Turn the fan motor assembly upside down in preparation for mounting the fan blade assemblies. Remove and discard five shipping retainers securing the motor in the motor housing.
NOTE: Take care not to scratch fan housing when installing blades.
9.Loosely attach one blade assembly to the motor using the two captive Phillips flange screws (Figure 6). Make sure the screws are NOT tight- ened. Repeat this procedure for the other four blade assemblies.
10.The blade flanges have an interlocking feature that must be fully engaged before tightening the screws. Make sure all the flanges are properly engaged and then tighten the flange screws. If one of the flanges does not seat properly on the motor, loosen the adjacent flange screws,
CAPTIVE PHILLIPS FLANGE SCREW
MOTOR
Figure 8
13.You have now completed the assembly of your new ceiling fan. You can now proceed with hanging and wiring your fan.
Electrical Requirements
Your new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit.
!WARNING
To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked “Acceptable for Fan Support of 50 lbs. or less”, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt.
BLADE FLANGE
Figure 6
11.Engage the connector of the switch housing assembly with the motor connector (Figure 7). The two connectors are keyed and
5
The outlet box must be securely anchored and capable of withstanding a load of at least 50 pounds.
If your fan is to replace an existing ceiling light fixture, turn electricity off at the main fuse box at this time and remove the existing light fixture.
!WARNING
Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.
