Emerson CF703WW02, CF702WW03, CF703PB02, CF704PB02, CF704W02 Switch Housing Assembly Mounting Screws

2.Remove the three switch cup screws from the switch housing plate. Position the switch housing assembly on the switch housing plate and align the holes in the switch housing assembly with the holes in the plate. Secure the switch housing assembly by installing the three screws (Figure 2).

!WARNING

To avoid possible fire or shock, do not pinch wires between the switch cup assembly and the switch

SWITCH

HOUSING

ASSEMBLY

MOUNTING
SCREWS (3)	SWITCH HOUSING
Figure 2	PLATE

3. Pass the 80" motor leads through the opening in the ceiling cover. Be sure the cover is oriented correctly.

4.Separate, untwist and unkink the three motor leads. Route the motor leads through the hanger ball/downrod assembly.

5.Remove the upper setscrew from the motor coupling. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 3). The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull on the hanger ball to make sure the clevis pin is properly installed.

!WARNING

It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.

CEILING

COVER

CLEVIS

PIN

3/16-24 x 1/2" SCREW WITH JAM NUT

MOTOR COUPLING

Figure 3

HANGER BALL/

DOWNROD ASSEMBLY

CLEVIS

PIN

HAIRPIN

CLIP

(3)3/16-24 x 5/16" SLOTTED PHILLIPS WASHER HEAD BLADE SCREWS

BLADE FLANGE

6. Install the 3/16-24 x 1/2’ screw with jam nut (supplied) in the motor coupling (Figure 3). While pulling up on the hanger ball, securely tighten the setscrew. Then securely tighten the nut against the motor coupling.

NOTE: The setscrew must be properly installed as described above, or fan wobble could result.

7.The fan comes with blue, black and white leads that are 80” long. Before installing fan, measure up approximately 6 to 9-inches above top of hanger ball/downrod assembly. Cut off excess leads and strip back insulation 1/2-inch from end of leads.

8. Turn fan assembly upside down in preparation for mounting fan blade assemblies.

9. Mount blade flanges to fan blades using three 3/16-24 x 5/16” screws per blade (Figure 4).

10. Attach blade assembly to motor hub using two 1/4-20 x 1/2” Phillips oval head flange screws. Make sure the screws are tightened securely (Figure 5). Repeat this procedure for other four blade assemblies.

NOTE: Take care not to scratch fan housing when installing blades.

11. You have now completed the assembly of your new ceiling fan. You can now proceed with the

hanging and the electrical wiring of your fan.

4

FAN BLADE

Figure 4

!WARNING

To reduce the risk of personal injury, do not bend the blade flanges when installing the flanges, balancing the blades, or cleaning the fan. Do not insert foreign objects in between rotating fan blades.

BLADE FLANGE

SCREWS

BLADE

ASSEMBLY

Figure 5