CAC CASSETTE EVAPORATOR FASCIA INSTALLATION INSTRUCTIONS
Assembly Instructions
1. To install the four fascia mounting bolts:
a)Remove the bolts and wash- ers from the supplied kit bag.
b)Put washers onto the bolts.
c)Screw the mounting bolt with washer into the chassis leav- ing approximately 1” to hang the fascia.
4.On
a)Ensure that the connector is in the proper orientation.
Female vane motor plug on chassis
Male vane motor plug on fascia
2.Ensure the white fi r tree fasteners holding the fascia polystyrene are pushed fi rmly in
(they may have 
sened in nsit).
3.Lift the fascia onto the chassis mount- ing bolts. Align the key hole brackets with the mounting bolts and slide the fascia forward to lock into position.
Note: The fascia only fi ts correctly one way. Position the fascia so that the AmericaSeries logo is on the control box end of the chassis.
b)Route the wires in a way that en- sures they won’t become trapped, cut, broken or chaffed.
5.The fascia can now be tight-
ened up to the Cassette chassis. Make sure a good seal is obtained between fascia and chassis, this is neces- sary to prevent recir- culation.
Note: Do not over tight- en the bolts. To do so may cause damage to the fascia.
With fi lter(s) in place, the inlet grille(s) can now be installed onto the fascia.
To complete the installation adjust the lou- ver position to 30° from plumb, this is recom- mended for
“optimum” system per- formance.
CAC Cassette Evaporator | 11 | www.enviromaster.com |
