Emerson CF716PW00 warranty Using Your Ceiling Fan, Three-Speed, Reverse Switch Information, Season

	BLACK AND BLUE	NOTE: CEILING COVER
SUPPLY		OMITTED FOR CLARITY.
GROUNDGROUND	FAN WIRES
WIREWIRE
LISTED		WHITE SUPPLY
WIRE
CONNECTOR (3)		(NEUTRAL)
GREEN WIRE
(GROUND) FROM		WHITE FAN
HANGER BRACKET		WIRE

	GREEN WIRE	BLACK SUPPLY
	(GROUND) FROM	(HOT)
Figure 12	HANGER BALL

! WARNING

Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.

3.Screw the two threaded studs (supplied) into the tapped holes in the hanger bracket.

4.Lift the ceiling cover up to the threaded studs and turn until studs protrude through the holes in the ceiling cover (Figure 13).

5.Secure the ceiling cover in place by sliding lockwashers over the threaded studs and installing the two knurled knobs (supplied). (Figure 13.) Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling and the hole in the ceiling cover is clear of the downrod. Your fan is now wired to be turned on and off from the fan switch.

CEILING COVER

THREADED STUD LOCKWASHERS (2) KNURLED KNOB

Figure 13

!WARNING

To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.

6.Cut the 3-speed switch pull chain to a desired length (optional). Connect the wood pendant (supplied) to the 3-speed switch pull chain by sliding the wooden pendant (small hole first) onto the pull chain. Attach the chain coupler to the end of the chain and allow the wooden pendant to fall down over the coupling.

Using Your Ceiling Fan

1.Restore electrical power to the outlet box by turning the electricity on at the main fuse box.

2.Check the operation of the fan by gently pulling on the pull chain switch.

3.All fans are shipped from the factory with the reversing switch positioned “down” to circulate air downward. If airflow is desired in opposite direc- tion, turn your fan OFF and wait for the blades to stop turning, then slide the reversing switch to the “up” position, and turn fan on again.

4.The fan blades will turn in the opposite direction and reverse the airflow.

Your fan model is equipped with a 4-position, 3-speed pull chain switch. The operating sequence is as follows:

Three-Speed

1st Pull—HIGH

2nd Pull—Medium

3rd Pull—Low	REVERSIBLE	SWITCH PULL
		SPEED CONTROL
	SWITCH	CHAIN
4th Pull—OFF
	Reverse Switch Information
Season	Rotation Direction	Switch Position
Summer	Counter-Clockwise	Down
Winter	Clockwise	Up

7 U.L. Model No.: CF716