Emerson CF725GBZ00, CF725GES00 owner manual SW102 FAN/LIGHT Wall Control Supplied

BP7369 Vienne 12/7/08 5:21 PM Page 10

SW102 FAN/LIGHT WALL

CONTROL (SUPPLIED)

TO	BLACK	BLACK
	(HOT)	BLACK
120-
VOLT		WHITE
SUPPLY	WHITE
		WHITE
	GROUND	RED
	TWO-CONDUCTOR	BLUE	WHITE
	CABLE (WITH
	GROUND)
	GREEN WIRE (GROUND)	BLACK
		BLUE
	FROM HANGER BALL AND	WHITE
Figure 11	HANGER BRACKET
		HANGER BALL

3. Push the wires and connectors up into the outlet box while inserting the receiver fully into the hanger bracket. Position the antenna wire on top of the receiver.

4. Screw the two 1-1/4” threaded studs (supplied) into the tapped holes in the hanger bracket (Figure 10).

5. Lift the ceiling canopy up to the threaded studs and turn until the studs protrude through the holes in the ceiling canopy (Figure 12).

6. Secure the ceiling canopy in place by sliding lockwashers (supplied) over the threaded studs and installing the two knurled knobs (supplied) (Figure 12). Tighten the knurled knobs securely until the ceiling canopy fits snugly

!WARNING

To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling canopy and the ceiling.

7.Engage the connectors of the housing downlight assembly with the connectors of the motor assembly (black to blue: white to white) (Figure 13).

8. Remove and retain one of the three M4 x 8mm oval head screws from the fitter adapter plate. Loosen the remaining two screws.

against the ceiling.

CEILING

CANOPY

1-1/4"

THREADED

STUD (2)

LOCKWASHER

(2)

	KNURLED
Figure 12	KNOB (2)

FITTER

ADAPTER

PLATE

BLUE WIRE

BLACK WIRE

HOUSING DOWNLIGHT ASSEMBLY

REMOVE ONE M4 x 8mm

OVAL HEAD SCREW . LOOSEN THE TWO REMAINING SCREWS.

WHITE WIRES

KEYHOLE SLOTS

Figure 13

10 U.L. Model No.: CF725