Emerson CF742PFWW, CF742PFOB warranty How to Hang Your Ceiling Fan, How to Wire Your Ceiling Fan

How to Hang Your Ceiling Fan

!WARNING

The fan must be hung with at least 7' of clearance from floor to blades (Figure 4).

CEILING

AT LEAST

7'

Figure 4 FLOOR

!WARNING

The outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs.

!WARNING

To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked acceptable for fan support, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician in in doubt.

1.Securely attach the hanger bracket to the outlet box using the two screws supplied with the outlet box (Figure 5).

OUTLET

BOX

TWO SCREWS
SUPPLIED WITH	HANGER
OUTLET BOX
	BRACKET

!WARNING

Failure to seat tab in groove could cause damage to electrical wires and possible shock or fire hazard.

	NOTE: CEILING COVER,
OUTLET	SUPPLY WIRES AND
	FAN WIRES OMITTED
BOX
	FOR CLARITY.

	HANGER
	BRACKET
Figure 6	HANGER BALL/
	DOWNROD ASSEMBLY

!WARNING

To avoid possible fire or shock, do not pinch wires between the hanger ball/downrod assembly and hanger bracket.

How to Wire Your Ceiling Fan

If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician.

!WARNING

To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. NOTE: If you are not sure if the outlet box is grounded, contact a licensed electrician for advice, as it must be grounded for safe operation.

1.Connect the green grounding lead from the hanger ball and the green grounding lead from the hanger bracket to the grounding conductor of supply (this may be a bare wire or wire with green colored insulation).

Figure 5 TAB

!WARNING

GROUND WIRE

BLACK AND BLUE FAN WIRES

NOTE: CEILING COVER OMITTED FOR CLARITY.

Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, remove wall board until bracket contacts box. If bracket and/or outlet box are not securely attached, the fan could wobble or fall.

2.Carefully lift the fan from the foam pad and seat the hanger ball/downrod assembly on the hanger bracket that was just attached to the outlet box (Figure 6). Be sure the groove in the ball engages with the tab on the hanger bracket (Figure 5).

WIRE CONNECTORS (3)

GREEN WIRE (GROUND)

FROM FAN

Figure 7

WHITE SUPPLY (NEUTRAL)

WHITE FAN

WIRE

BLACK SUPPLY (HOT)

5