Emerson CF935TG00, CF935BC00 warranty Using Your Ceiling Fan, Maintenance, Accessories, Three-Speed

GROUND

WIRE

LISTED

BLACK AND BLUE FAN WIRES

5. Secure the ceiling cover in place by sliding lock-

washers over the threaded studs and installing the

two knurled knobs (supplied). (Figure 13.) Tighten

the knurled knobs securely until the ceiling cover

WIRE

CONNECTOR (3)

NOTE: CEILING COVER

OMITTED FOR CLARITY.

GREEN WIRE (GROUND) FROM HANGER BRACKET

GREEN WIRE

Figure 12 (GROUND) FROM HANGER BALL

WHITE SUPPLY (NEUTRAL)

WHITE FAN

WIRE

BLACK SUPPLY (HOT)

fits snugly against the ceiling and the hole in the

ceiling cover is clear of the downrod. Your fan is

now wired to be turned on and off from the fan

switch.

	CEILING
	COVER
THREADED	LOCKWASHERS (2)

!WARNING

Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.

3.Screw the two threaded studs (supplied) into the tapped holes in the hanger bracket.

4.Lift the ceiling cover up to the threaded studs and turn until studs protrude through the holes in the ceiling cover (Figure 13).

Figure 13 STUD

KNURLED KNOB

!WARNING

To avoid possible fire or shock, make sure that the elec- trical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.

6.Cut the 3-speed switch pull chain to a desired length (optional). Connect the wood pendant (sup- plied) to the 3-speed switch pull chain by sliding the wooden pendant (small hole first) onto the pull chain. Attach the chain coupling to the end of the chain and allow the wooden pendant to fall down over the coupling.

Using Your Ceiling Fan

1.Restore electrical power to the outlet box by turning the electricity on at the main fuse box.

2.Check the operation of the fan by gently pulling on the pull chain switch.

3.All fans are shipped from the factory with the reversing switch positioned to circulate air down- ward. If airflow is desired in opposite direction, turn your fan off and wait for the blades to stop turning, then slide the reversing switch to opposite position, and turn fan on again. The fan blades will turn in the opposite direction and reverse the airflow.

Your fan model is equipped with a 4-position, 3-speed pull chain switch. The operating sequence is as follows:

THREE-SPEED

1st Pull—HIGH		SPEED CONTROL
	REVERSING	SWITCH PULL
2nd Pull—Medium		CHAIN
	SWITCH

3rd Pull—Low 4th Pull—OFF

Maintenance

IMPORTANT CARE INSTRUCTIONS

for your Ceiling Fan

Periodic cleaning of your new ceiling fan is the only maintenance that is needed.

When cleaning, use only a soft brush or lint free cloth to avoid scratching the finish.

Abrasive cleaning agents are not required and should be avoided to prevent damage to finish.

!WARNING

Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and create the possibility of an electrical shock.

Accessories

1.Ceiling Fan Light Kits (see store or catalog).

2.Ceiling Fan/Light Controls (see store or catalog).

3.Downrod Extension Kits (see store or catalog).

!WARNING

The use of any other control not specifically approved for this fan could result in fire, shock and personal injury.

7

!WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or acces- sories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.