Emerson EWD2203 owner manual Hookups, DVD/VCR to TV Connection, Connecting to a TV

HOOKUPS

CAUTION:

¡Be sure to turn off the DVD/VCR COMBINATION UNITS and equipment to be connected before connecting. ¡Read through the operation manual for the equipment to be connected.

¡Be sure that the colors of the jacks and plugs match up when using VIDEO/AUDIO cables.

¡Be sure to keep the DVD/VCR COMBINATION UNITS connection cables separate from the TV antenna cable when you install the DVD/VCR COMBINATION UNITS, because it may cause electrical interference when you are watching television programs.

DVD/VCR TO TV CONNECTION RF OUTPUT CHANNEL

1.Disconnect the AC power cord of the TV from the AC outlet.

2.Disconnect the antenna or cable from the TV.

3.Connect the antenna or cable to the ANT-IN jack of the DVD/VCR COMBINATION UNITS.

4.Connect the DVD/VCR COMBINATION UNITS to the TV using the RF cable.

5.Plug the AC power cords of the DVD/VCR COM- BINATION UNITS and TV into the AC outlets.

[VHF/UHF	[Indoor antenna]	[Back of the DVD/VCR]
combination antenna]				[Back of the
				UHF/VHF combination TV]
		OR		RF cable
		ANT-IN	VCR	(supplied)
		DVD/VCR
		AUDIO OUT
[Cable	box or satellite box]	L		UHF/VHF
		OR	AUDIO IN
		R

ANT-OUT VIDEO OUT

From Cable or	VIDEO IN
Satellite Company

If your TV does not have A/V terminals:

1.Connect the DVD/VCR COMBINATION UNITS to a TV using RF cable (see DVD/VCR TO TV CONNECTION).

2.Select channel 3 on your TV.

3.Press PLAY.

¡If noise appears, change the RF output channel of the VCR to channel 4 by pressing PLAY for 3 sec- onds during playback.

¡There is case that the RF output channel does not change by situation (For example, when you adjust tracking using CHANNEL(UP/DOWN)).

In this case, stop the playback, and start the play- back again. After that, press PLAY on the VCR for 3 seconds.

¡If there is a power failure or the DVD/VCR COM- BINATION UNITS is unplugged for more than 30 seconds, the RF output channel setting will return to CH3.

Note to CATV system installer

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that pro- vides guidelines for proper grounding and, in particular, specifies that the cable ground should be connected to the grounding system of the building, as close to the point of cable entry as practical.

CONNECTING TO A TV

Antenna/Cable signal	DVD/VCR	VCR	OUT	DVD
	ANT-IN			VIDEO OUT OUT
	AUDIO OUT		S-VIDEO COMPONENT AUDIO
	L			Y
A/V-compatible or	R	AUDIO IN		Cb	L
	ANT-OUT VIDEO OUT
wide screen TV		VIDEO IN		Cr	R
To ANT. IN
of TV
To VIDEO INPUT jack			To VIDEO OUT jack

DIGITAL

AUDIO OUT

COAXIAL

To Right (red) and Left (white)

To AUDIO INPUT jacks To AUDIO OUT jacks [Fig. 1]

Notes

¡Connect the DVD/VCR COMBINATION UNITS directly to a TV. If the A/V cables are connected to a VCR, pictures may be distorted due to the copy protection system.

– 13 – EN

1L25