Emerson HAS60E-IM-HW

NGA 2000 CLD

Instruction Manual

HAS60E-IM-HW

June 2007

3 - 8 Operation Emerson Process Management GmbH & Co.OHG

3-5 SYSTEM & NETWORK I/O MODULE

CONTROLS (SETUP) - SYSTEM SIO

To adjust SIO functions, select

Main (Menu)...

Analyzer and I/O, expert controls & setup...

System & network I/O module controls...

System SIO module...

Figure 3-11: System SIO Module Menu

System SIO module menu allows you to adjust different

SIO functions, like analog outputs and serial interfaces.

a. Analog Output Setup

In the System SIO Module menu (Figure 3-11) select

"Analog output setup..."

Figure 3-12: Analog Output Setup Menu

Output number:

Choose the desired analog output (1-8) to set the pa-

rameters. The number of outputs depends on the ana-

lyzer configuration as 2, 4, 6 or 8.

Choose signal source module...

Select the "Analyzer Modules" submenu by selecting the

"Choose signal source module..." line and pressing the

Return (↵) softkey.

Select the tag of the desired reference channel with the

↑ or ↓ softkeys and then press the ↵ or → softkey. The

display will return to the previous menu automatically and

the selected reference channel will be displayed in the

"Source module:" line.

The available selections may be different depending on

the installed modules.

Figure 3-13: Analyzer Modules Menu

Choose Signal...

Select the "Signals" submenu by selecting the "Choose

Signal..." line and pressing the ↵ softkey. (The list of sig-

nals will depend on the module chosen.)

Press the F5 softkey to go to additional menus to choose

the Primary Variable signal for the analog output. The

Primary Variable is the actual NO or NOx concentration.

See Section 5.2.1.1 of CLD Software Manual for com-

plete list of signals.

The signal chosen here will be applied to the analog out-

put (1-8) chosen above.

Line#1

MEASURE

0.000 ppm

Back...

YES

-- System SIO Module --

Analog output setup...

Serial interface setup...

Relay outputs setup...

Module installed...

Line#1

HOME NO/NOx INFO

0.000 ppm

Control Module: 0.0

1000723 Line#1: 1.0

CLD: 1.0

MLT/CH3

ZERO SPAN

-- Analyzer Modules --

Line#1

Measure More...

0.000 ppm

Back...

-- Analog Output Setup --

Output number:

Choose signal source module...

Choose signal...

Signal value for 0% output:

Signal value for 100% output:

Output current:

Hold output during calibration:

Signal name:

Current signal value:

Source module:

0.00

100.00

0...20 mA

????

-10.00

Line#1