Emerson HD7999 owner manual Normal CD Playback

NORMAL CD PLAYBACK

•Make sure you have installed the batteries.

•Make sure the HOLD switch is set to the ‘Off’(left) position.

•Make sure to set the VOLUME control to a low setting before you put on the headphones.

IMPORTANT:

This CD player can play normal CDs plus CD Recordable (CD-R) and CD Rewriteable (CD-RW) discs. However the playability of CD-R and CD-RW discs may be affected by the type of software that was used in ‘ripping’the tracks from the original discs and ‘burning’the tracks onto the blank media. Playability may also be affected by the quality and condition of the blank media you use for recording. 100% compatibility cannot be guaranteed. This is not an indication of any problems with your player.

1.) Slide the CD door OPEN switch to the right to unlock and open the CD door.

OPEN

2.) Place your CD on the center spindle with the printed label side facing up. Press downward on the disc near the center hole until the disc is fully seated on the spindle.

3.) Close the CD door and connect the headphones to the headphone jack (green color) by pushing the headphone plug the into headphone jack until a ‘click’ sound is heard.

4.) Press the PLAY/PAUSE button to begin

playback. The “ – – “ flashes while the player reads the disc. The total tracks will appear briefly in the display and then the playback

will begin on track 1. The display will show the track being played.

5.) Adjust the VOLUME, and BASS controls as desired.

10

HD7999_031004.p65 10

11/3/2004, 10:15