Checking Contents of Package
1.Unpack the items carefully to avoid damage to any of the components.
Check to see that you have received the following parts:
NOTE: If you are uncertain of part description, refer to the exploded view illustration.
a.Fan motor assembly
b.One ceiling cover
c.One motor cover
d.Three fan blades assemblies
e.One hanger bracket
f.One hanger ball/downrod assembly
g.One loose parts bag, containing:
1.One clevis pin
2.One hairpin clip
3.Three wire connectors
4.Seven
5.Seven split lockwashers
6.Seven flat washers
7.Two M4
8.Two M4 external tooth lockwashers
9.Two
10.Two #8 external tooth lockwashers
11.Two
12.Two safety wire clamps
13.One eye screw
14.One setscrew wrench
NOTE: Intermixing blades between fans can cause excessive wobble. Keep blades in original sets of three.
!WARNING
Do not install or use fan if any part is damaged or missing. Call
1-800-654-3545
!WARNING
This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Company. Substitution of parts or accessories not designated for use with this product by Emerson Company could result in personal injury or property damage.
Electrical Requirements
Your new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit.
The outlet box must be securely anchored and capable of withstanding a load of at least 50 pounds.
!WARNING
To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked “Acceptable for Fan Support of 50 lbs. or less”, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt.
If your fan is to replace an existing ceiling light fixture, turn electricity off at the main fuse box at this time and remove the existing light fixture.
!WARNING
Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.
Assembly Instructions
CAUTION: The blade assemblies must be mounted on the motor assembly so that the “This Side Up” label is visible at the top of the motor (Figure 1).
1.Install one blade assembly on the top of the motor assembly using two
HEX HEAD SCREW
SPLIT LOCKWASHER | SETSCREW (2) |
FLAT WASHER |
|
BLADE | MOTOR |
YOKE | |
ASSEMBLY |
|
LABEL |
|
MOTOR ASSEMBLY
3Figure 1