2.Using the setscrew wrench (supplied), remove the two setscrews from the top of the motor yoke (Figure 1). Retain the setscrews for future use.
3.Route the three 48” motor leads and the safety cable through the center hole in the motor cover. Align the two holes in the motor cover with the threaded holes in the motor yoke and secure by installing two
KNURLED SCREW
M4 EXTERNAL TOOTH | SAFETY |
LOCKWASHER | CABLE |
MOTOR COVER 
Figure 2
4.Route the three motor leads and the safety cable through the center hole in the ceiling cover and position the ceiling cover over the motor yoke (Figure 3).
5. Separate, untwist and unkink the three motor leads and the safety cable, then route them through the hanger ball/downrod assembly and seat the downrod in the motor yoke (Figure 3).
HANGER | SAFETY |
BALL/DOWNROD | CABLE |
ASSEMBLY |
|
CEILING COVER |
|
HAIRPIN | DOWNROD |
CLIP | |
| MOTOR YOKE |
| CLEVIS |
SETSCREW | PIN |
Figure 3
6.Align the clevis pin holes in the downrod with the holes in the motor yoke. Install the clevis pin and secure with the hairpin clip (Figure 3). The clevis pin must go through the holes in the motor yoke It is critical that the clevis pin in the motor yoke is properly installed and the setscrews securely tightened. Failure to verify that the pin and setscrews are properly installed could result in the fan falling.
!WARNING
It is critical that the clevis pin in the motor coupling is properly installed and the setscrews securely tightened. Failure to verify that the pin and setscrews are properly installed (as shown in Figure 3) could result in the fan falling.
7.Install two setscrews (previously removed in Step 2) in the motor yoke (Figure 3). While pulling up on the hanger ball, securely tighten both setscrews using the setscrew wrench (supplied).
NOTE: The setscrews must be properly installed as described above, or fan wobble could result.
!WARNING
The fan must be hung with at least 10' of clearance from floor to blades (Figure 4).
CEILING
AT LEAST
10'
FLOOR
Figure 4
!WARNING
The outlet box and joist must be securely mounted and capable of supporting at least 50 lbs. Use only a U.L. outlet box listed as “Acceptable for Fan Support of 50 lbs. or less”.
!WARNING
To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked “Acceptable for Fan Support of 50 lbs. or less”, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt.
8.Securely attach the hanger bracket to the outlet box using the two screws supplied with the outlet box (Figure 5).
!WARNING
Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, remove wall board until bracket contacts box. If bracket and/or outlet box are not securely attached, the fan could wobble or fall.
4
