INTRODUCTION

5Supplied Accessories

owner’s manual

quick start guide

remote control

batteries

Phillips pan screw for

(1EMN24520)

(1EMN24607)

(NH000UD)

(AAA x 2)

attaching the stand x 3

 

 

 

 

 

 

 

 

 

 

 

(FPH34120)

 

 

 

 

 

 

 

 

 

 

 

AAA

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

AAA

If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual.

5Attaching the Stand

You must attach the stand to the unit to have it as a table top unit. Be sure the front and rear of the stand match the proper direction.

1Spread a thick and soft cloth over a table as shown below.

Place the main unit face down onto it. Make sure not to damage the screen.

2Align the 2 stand hooks with the two hooks under the bottom of the main unit (shown by arrow ), then slide the stand in the direction as shown by arrow until it stops and the 4 mounting holes are aligned.

Make sure not to put the AC power cord between the stand and the unit.

3 Drive Phillips pan screws in the 3 threaded holes at the bottom of the stand until they are tight.

Žscrew holes



 

front

side

Œ

 

 

 

 

 

To remove the stand from this unit

 

 

Œ

Unscrew the Phillips pan screws indicated by above “”screw holes.

After the screws are removed pull the stand up toward the rear of the unit. Be careful not to drop the stand when you remove it.

Note:

When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall, resulting in injuries as well as damage to the unit.

Make sure to use a table which can support the weight of this unit and is larger than this unit.

Make sure the table is in a stable location.

5Symbols Used in this Manual

The following is the description for the symbols used in this manual. Description refers to:

TV : Analog TV operationDTV : Digital TV operation

• If neither symbol appears under the function heading, operation is applicable to both.

4

EN

Page 4
Image 4
Emerson LC195EMX owner manual Introduction, 5Supplied Accessories, 5Attaching the Stand, 5Symbols Used in this Manual