Emerson I-0021, NGA 2000 manual 134

You have to put in the codes of the table into the corresponding lines of the submenu "Program". If the program consists of more than ten steps, you can change to another menu page with the F5 key. Maximum of program steps: 100. Maximum of results: 4 Maximum of constants: 4.

Putting the program steps in the menu:

¨Select the program steps with the − -key or the ↓ -key.

¨Select the field for the code number with the 8 -key or the → -key.

¨Select any digit with the ← -key or the → -key and adjust the code number with the − -key or the ↓ -key. If necessary, change the sign (+/-) with the F4 key.

¨Confirm the code with the 8 -key or cancel and go back to the last value with the F2 key.

TAG							95.00 ppm
Program offset (o):			-- Program --			0
Step	(o+1):					-1
Step	(o+2):					5
Step	(o+3):					-1
Step	(o+4):					10
Step	(o+5):					-13
Step	(o+6):					1
Step	(o+7):					-9
Step	(o+8):					1
Step	(o+9):					-8
Step	(o+10):					1
Measure					Back...		More...
F1		F2	F3	F4		F5

TAG							95.00 ppm
Program offset (o):			-- Program --			10
Step	(o+1):					-14
Step	(o+2):					1
Step	(o+3):					-17
Step	(o+4):					0
Step	(o+5):					0
Step	(o+6):					0
Step	(o+7):					0
Step	(o+8):					0
Step	(o+9):					0
Step	(o+10):					0
Measure					Back...		More...
F1		F2	F3	F4		F5

Start the calculation with "Enabled" in the line "Calculator is" of the menu "Programmable Calculator". The results will appear in the last four lines of that menu.

5 - 48 NGA 2000

90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98