Emerson I-0021, NGA 2000 manual 135

5.1 Analyzer Module Setup

5.1.8 Measurement Display Configuration

Main Menu — Analyzer and I/O-module expert configuration

					↓
			Analyzer module setup
					↓
		Measurement display configuration
					↓
TAG									95.00 ppm
	-- Measurement Display Configuration (1/2) --
Displayed concentration digits:							4
Digits after decimal point:							2
Display confirmation menus:										Yes
Signal on mini-bargraph - 1:							Temperature
Signal on mini-bargraph - 2:					Maintenance-Requests
Signal on mini-bargraph - 3:							Any_Alarms
Signal on mini-bargraph - 4:								Operation
Measure				Channel		Back...			Tags...
F1	F2		F3		F4			F5

In the menu "Measurement Display Configuration" you can determine

¨the parameters for the single component display for one channel of an MLT analyzer or analyzer module. To set up the conditions of the other channels, you have to press the F3 key.

¨the display of the confirmation menus.

¨the tags of the MLT analyzer or analyzer module and the tags of each range for the current channel (2nd page of the menu).

Caution:

If you change the identification tag, you have to change the configuration of the programmable digital inputs and analog outputs. Because, the parameters of the module source will change! So, the relations will disappear !

Set up parameters:

¨Select any line of variables with the ↓ -key or the − -key.

¨Select the variable with the 8 -key or the → -key.

¨Adjust a new value with the − -key or the ↓ -key

resp. select the whole parameter with the − -key or the ↓ -key.

¨Confirm the new value with the 8 -key or

cancel and go back to the last value with the F2 key.

90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98

NGA 2000 5 - 49