6 System Configuration and Diagnostics
If you press the 8
TAG | 37.50 ppm |
System calibration...
Diagnostic menus...
Date and time...
Security codes...
Network module binding...
System Reset...
System modules... |
|
|
| |
System tag: |
|
| ||
Measure |
| Channel | Back... |
|
F1 | F2 | F3 | F4 | F5 |
From the menu "System configuration" you can change to several submenus to set up the system parameters of the platform or of the MLT analyzer. Besides you can set up or control the software and hardware configuration of the control module or the analyzer modules.
In the following table you will find a short overview about the contents of the menus and where you will find their description in this manual:
Menu | Important Contents | Section/Page | |
|
|
| |
System calibration... | Þ Calibration of all analyzer modules in a | * See | |
| common process | ||
Diagnostic menus... | Þ Error messages of the control module | * 6.1 / p. 3 to 5 | |
| and analyzer modules' software |
|
|
Date and time | Þ Date and time setup of the control | ||
| module (platform or MLT analyzer) |
|
|
Security codes... | Þ Setup of security codes for the different | * 6.3 | / p. 7, 8 |
| operating levels |
|
|
Network module binding... | Þ Binding of analyzer modules with micro | * 6.4 | / p. 9, 10 |
| processor controlled I/O modules, which |
|
|
| are connected with the platform |
|
|
System Reset... | Þ System reset of the control module and | * 6.5 | |
|
|
| |
System modules... | Þ Overview of all modules connected to | * 6.6 | |
| the control module |
|
|
(platform or MLT analyzer)
90003482(2)
NGA 2000 | 6 - 1 |