CLD

95.0 ppm

Analyzer span

Are you sure?

You must have span gas flowing through the analyzer.

This control does NOT control any auto-calibration module bound to this analyzer!

 

If you are sure, press SPAN again now.

 

 

 

 

Press the left arrow key when you are done.

 

 

 

 

Calibration status:

 

 

 

 

 

 

READY

 

Error message for last span:

 

 

 

CAL OK

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

HOME

 

ESCAPE

 

 

 

SPAN

 

INFO

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

F1

 

F2

F3

F4

 

F5

CLD

95.0 ppm

Analyzer span

Are you sure?

You must have span gas flowing through the analyzer.

This control does NOT control any auto-calibration module bound to this analyzer!

 

If you are sure, press SPAN again now.

 

 

 

 

Press the left arrow key when you are done.

 

 

 

 

Calibration status:

 

 

 

SPANNING - WAIT

 

Error message for last span:

 

 

CAL OK

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ABORT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

F4

 

 

 

 

F1

F2

F3

F5

 

 

 

 

 

 

 

 

 

 

 

 

CLD

225.0 ppm

Analyzer span

Are you sure?

You must have span gas flowing through the analyzer.

This control does NOT control any auto-calibration module bound to this analyzer!

 

If you are sure, press SPAN again now.

 

 

 

 

Press the left arrow key when you are done.

 

 

 

 

Calibration status:

 

 

 

 

 

 

READY

 

Error message for last span:

 

 

 

CAL OK

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

HOME

 

ESCAPE

 

 

 

SPAN

 

INFO

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

F1

 

F2

F3

F4

 

F5

Start Spanning + Pay attention to the note at p. 4-27 !

F4

Press

Caution:

You have to

·flow enough span gas through the analyzer

·look for a stable signal

before starting the span gas calibration.

Note:

You can go back to the menu "Basic Controls" with the F2 key.

Span gas calibration is running

Note:

You can abort the procedure at any time with the F2 key.

Change to the main menu

F1

Press

Alternative:

If you want to continue with further setups of the basic controls, you can go back to the corresponding menu with the F2 key or the -key.

4 - 26

NGA 2000

90003749(1) [NGA-e (Software CLD 2.3/MLT 3.1.X)] 04/98