SSVC Kn S621 a | Loading/Saving of device specific parameters |
Description: | With this command you can load/save the device specific parameters. This will be possible | ||
| via the serial interface and from /to the internal FLASH memory (if on ACU available!). | ||
Syntax: | a = | 1: | loading new configuration via the serial interface. |
|
| 2: | sending out the current configuration via the serial interface |
|
| 3: | saving the current configuration in the FLASH memory |
|
| 4: | loading the configuration saved in the FLASH memory |
Notes: | The data format for the loading via the serial interface (a = 1) corresponds to the data format | ||
| of the serial sending out (a = 2). | ||
| Some peculiarities will have to be heeded, because the serial interface will be used parallel | ||
| for AK and for | ||
| For a = 1 you will have to wait for the AK response, before you will start the sending of the | ||
| data stream. |
| |
| For a = 2 the AK response ("<STX><don’t care>SSVC 0<ETX>") will be sent at first. It will | ||
not | be necessary to treat these response signs in a certain way, because this line will be deleted | ||
| as invalid stream! | ||
| Saving the configuration in the FLASH memory (a = 3) will overwrite the factory settings of | ||
| the device !! |
| |
| With a = 4 the factory settings will be reloaded to the RAM memory and so to the actual | ||
| working memory. | ||
Cf.: | Instruction manual | ||
Supplement - 6 | AK | 90003752(1) |