Emerson Remote Monitoring Panel user manual Mounting the RMP on Drywall, UPSU2J24

Installation

Figure 4 Communication cable connection

	RMP_X1_J1
4	485-
3	485+
2	Shield
1

Up to 328ft. (100m)

Shield 485+

485-

UPS_U2_J24

1

2

3

4

2.5Mounting the RMP on Drywall

To hang the RMP on drywall or similar surface:

1.Drill four holes (6mm-by-26mm) in the wall, spacing them as shown in Figure 5.

2.Insert the four factory-supplied, plastic anchors into the holes.

3.Insert one screw into each anchor and tighten firmly.

4.Remove the four hooks from the RMP, reverse them, then reattach them to the RMP.

5.Hang the RMP on the wall by slipping the hooks over the heads of the screws and lowering the RMP slowly until the screws are seated in the slotted portion of the hooks.

Figure 5 Mounting hole dimensions

14-3/16" (365mm)

EmersonTM	Liebert NX
Network Power

Remote Monitor Panel

S TATUS SILENCE ON/OFF

F1 F2 F3 F4 HELP

12"

(306mm)

5