Emotiva A-100 user manual Specifications

Specifications

Analog inputs:

Unbalanced (RCA); one stereo pair

Analog outputs (loop):

Unbalanced (RCA); one stereo pair

Input sensitivity (for full output):

600 mV (8 ohm load)

Speaker outputs:

5-way binding posts; one stereo set

Minimum recommended load impedance:

4 ohms (which equals one 4 ohm load or two paralleled 8 ohm loads per channel)

Power output:

50 watts / channel RMS; continuous into 8 ohms; 20 Hz - 20 kHz; <0.05% THD; both 2 channels driven (FTC)

80 watts / channel RMS; continuous; into 4 ohms

S/N ratio:

> -95 dB (A-weighted)

Frequency response:

20 Hz to 20 kHz + / - 0.08 dB at 1 watt (- 1 dB at 80 kHz)

Front panel controls and indicators:

Volume; analog potentiometer with machined aluminum knob, illuminated Status ring, and pinpoint Position LED (Illuminated ring changes color to indicate status)

Back panel controls:

AC Power switch

Line Voltage (protected slide switch)

Power Mode switch (On, Off, Auto)

Trigger and control:

Trigger Input: 5-12 VDC

Auto-sense of audio input signal

Trigger Output: 12 VDC 120 mA max

Protection:

The Mini-X A-100 is protected against excessive operating temperature, shorted

speaker connections, ground faults, and other common fault conditions. If a fault occurs, the Mini X will return to Standby mode and the illuminated ring (around the Volume control) will flash Amber to indicate a fault condition.

Power requirements:

115 VAC or 230 VAC +/- 10% @ 50 / 60 Hz (selectable by rear-panel switch)

Dimensions:

8.5” wide x 3.125” high x 15” deep (includes feet, binding posts, and Volume knob)

Weight:

11.8 lbs ; 15 lbs (packaged)

Page 13