Emotiva ERM-6.3, ERM-1, ERM-6.2 manual ERD-1Wall Mounting, Connection Tips for Superior, Connections

ERD-1 Wall Mounting

Caution: Do not over tighten the mounting screws on the back of the ERD-1 speaker. They are not designed to sit flush and over tightening can strip the insert into which the screw is attached. Remove the grilles before installing the speakers, and mount them only when speakers are in a fixed, stable position.

1) The ERD-1 is designed to be wall mounted with the included mounting plate. Please use wall anchor hardware capable of supporting up to 20 pounds or mount the plates directly against a wall stud with the appropriate hardware. Do not use drywall screws to mount these plates!

2) When positioning the plate for hardware location/installation, the Emotiva logo should be facing outwards, towards you, as you place it on the wall.

3) Use a stud-finder to determine the location of a stud and that will determine your choice of hardware. Carefully drill the wall and install the appropriate hardware to mount the bracket.

4) When the bracket is mounted, install 2 foam strips on each bracket. Peel the cover on the adhesive side of the strips and stick them to the ridges that run vertically between the top and bottom keyholes on each side of the mounting plate. (Foam strips may be attached at factory. If so, go directly to step 5).

5) Set the switches (see page 14) for the mounting position and configuration (5.1, 7.1, Surround or Side, etc.).

6) Carefully lift the speaker to the plate and connect the wiring to the terminals. Then, lining up the mounting screws to the keyholes, let the speaker gently slide down into place on the bracket.

Connections

Connection Tips for Superior

20