Emotiva UPA-1 Other Probable Causes of Noise, A fault condition is one or more of the following

Models: UPA-1 UPA-5

1 36
Download 36 pages 43.22 Kb
Page 29
Image 29

Ground loop isolators are available for audio lines and video devices. If you need assistance, contact Emotiva. Although this is not always an ideal solution, the grounding differences between certain home entertainment components sometimes require ground loop isolators. This is the exception rather than the rule.

Other Probable Causes of Noise

Speaker noise may also be caused by interference or noise on your AC line. Make sure there are no large appliances sharing the line, or halogen lamps or light‐dimming Triac devices.

Try connecting your system to another AC socket on a separate line.

If the hum is heard from within the amplifier, and not through the speakers, this may also be caused by interference on the AC or DC lines. The power transformers may turn this interference into an audible noise. Internal hum can be made worse by a shelf or cabinet resonating, so try moving the amplifier to another shelf.

Try moving your components further away from the TV, especially if you notice the screen has changed color in the area closest to the component.

If you have very high efficiency speakers, these may tend to reveal noises, which other speakers do not.

One or more RED lights on the Front Panel are Blinking

Your Ultra Series Amplifier is equipped with a ‘Protect Mode’ to minimize the possibility of damage to either itself or speakers. If a problem is detected, the channel(s) at risk will shut down, following a red blinking on the corresponding indicator light(s).

Each RED light indicates a fault condition for the corresponding power module.

A fault condition is one or more of the following:

Excessive Operating Temperature

Excessive Current (Short Circuit)

DC on the Outputs

An excessive temperature fault can be reset by allowing amplifier to cool and cycling power on/off button on the front panel. Excessive current (short circuit) can be reset by removing the cause of the short and cycling power on/off button on the front panel. DC at output is a possible fault condition that is equipment related and requires technical assistance. Please contact Emotiva if you have repeated problems causing the RED front panel light to flash that are NOT thermal or short circuit related.

Problems with the whole A/V System

If you are having more complex problems in your overall home entertainment system (not just with the amplifier), please contact Emotiva Support for assistance. 877‐EMO‐Tech (877‐366‐8324)

29

Page 29
Image 29
Emotiva UPA-1, UPA-5 manual Other Probable Causes of Noise, A fault condition is one or more of the following