FOR YOUR SAFETY READ BEFORE LIGHTING 
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS •Do not try to light any appliance. •Do not touch any electrical switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone, Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it; call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING INSTRUCTIONS
1.STOP! Read safety information above.
2.Set the thermostat to lowest setting.
3.Turn off all electric power to the appliance.
4.Remove control access panel (lower front panel).
5.Turn gas control knob clockwise
to “OFF.”
GAS CONTROL KNOB SHOWN
IN “OFF” POSITION.
6.Wait ten (10) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Fol- low “B” in the safety information above. If you don’t smell gas, go to the next step.
7.Remove the pilot access cover located on the combustion chamber.
9.Turn gas control knob counterclockwise to “Pilot.”
10.Push and hold red reset button down completely and repeatedly push the ignitor button until the pilot burner is lit. Pilot may also be lit with a match. Continue to hold the red rest button down for about one (1) minute after the pilot is lit. Release button and it will pop back up. Pilot should remain lit. If it goes out, repeat step 5 through 10.
•If button does not pup up when released, stop and immediately call a qualified service technician or gas supplier.
•If the pilot will not stay lit after several tries, turn the gas control knob to “OFF” and call your service technician or gas supplier.
11.Replace pilot access cover.
12.Turn gas control knob counterclockwise
to “ON.”
13.Replace control access panel (lower front panel).
14.Turn on all electric power to the appliance.
15.Set thermostat to desired setting.
8. Find pilot - follow metal tube from gas control. The pilot
is located between the two burnerPILOT BURNERTHERMOCOUPLE tubes behind the pilot access
cover.
TO TURN OFF GAS TO APPLIANCE 
1.Set the thermostat to lowest setting.
2.Turn off all electric power to appliance if service is to be performed.
3.Remove control access panel (lower front panel).
4.Pushingascontrolknobslightlyandturnclockwise to “OFF.” Do not force.
5.Replace control access panel (lower front panel).
Page 9 |
