8X DDS DVD± R/RW Drive

Cable Select

Slave Master

Jumper

The system might not detect the drive if there is conflict or mistake with the jumper setting.

Hardware Installation

1.Turn off the power to your computer system.

2.Disconnect the power cord and all cables from the back of your computer, and then remove the cover of the computer.

3.Insert the drive into one of the vacant 5.25" drive bays and secure it to your PC with all four mounting screws.

4.Connect one end of the 40-pin IDE cable to the IDE connector of this drive and the other end to the IDE port on your motherboard. Also, connect the power supply cable to the back of the drive.

Audio Out

Power In

Digital

red edge

Audio Output

 

Make sure to align and connect the red-edge of the IDE Cable to Pin 1 on the drive.

4