England's Stove Works 13-NCL 50-SNC13L 50-TNC13L operation manual Side Heat Shields, Brick Layout

3. Side Heat Shields

This accessory item comes with the hardware (six (6) mounting screws) necessary to install it on the rear of the stove. This is a two-piece heat shield, but is installed one piece at a time. There are pre- punched holes on each side of the Rear Heat Shield; while holding each piece of the Side Heat Shield in place, align the pre-punched holes in the Side Heat Shield with the existing holes in the Rear Heat Shield, and fasten with the screws provided.

See Illustration 1 for clearances with and without side heat shields.

Side

Heat

Shield

Rear Heat Shield

Side

Heat

ShieldInstall AC-16 Optional Blower on these (4) mounting holes. See “Optional Blower Instructions” on page 3 for instructions.

Illustration 3 – Side Heat Shield and Blower Installation

Steel

Riser

5

Illustration 4

		BRICK LAYOUT
1	– 9” x 4” x 1.25” brick (Qty. 14)		3 – 4” x 2” x 1.25” brick (Qty. 1)
2	– 9” x 4” x 1.25” brick w/ .75 x .75 notch	(Qty. 2)	4	– 4.5” x 4” metal plate (Ash Drawer Plate, Qty. 1)
			5	– 4” x 4.5” x 1.25” brick (Qty. 1)