Pellet Stoves
Wood Stoves
Gas Stoves
P.O. Box 206 Monroe, VA 24574 www.englanderstoves.com Phone: (800)
Installing the PU-DTSTAT
BEFORE BEGINNING THERMOSTAT INSTALLATION BE CERTAIN THE STOVE IS UNPLUGGED AND COMPLETELY COOL. DEPENDING ON WHICH STOVE THE THERMOSTAT IS BEING INSTALLED ON, THE CONTROL BOARD MAY NEED TO BE REMOVED FOR INSTALLATION.
1.Using a small, slotted screwdriver (often referred to as a jeweler’s screwdriver), loosen the two screws on the front of the J18 thermostat terminal, shown below and remove the jumper which is installed in the terminal from the factory. This jumper should be set aside and saved.
Connect
thermostat wires here (J18)
2.Insert one of the thermostat wires into each of the terminals on the bottom of the J18 thermostat connection block and tighten the screws on the front of the thermostat terminal. The thermostat wires should be securely held in place by these screws (remember that the thermostat is not polarity specific, so it will not matter which wire goes into either terminal).