4-3

Using the Address Translation Table

Editing the Address Translation Table
You can modify existing entries in, or add new entries to the Address Translation
Table.
Modifying Entries in the Address Translation Table
By modifying an entry in the Address Translation Table you will change the
mapping that was discovered by the ARP process.
1. Click on an entry in the Address Translation Table. That entry’s corresponding
values for its Port Number, Physical Address, and IP address display in the
Values set for area.
2. Enter the desired changes in the Physical Address field within the Valu es
set for area.
3. Click on Set. Status information displays above the command buttons and a
confirmation window opens; if the set succeeded, the changes appear in the
display panel.
Adding Entries to the Address Translation Table
1. Click on Clear. This allows you to enter values in the Values set for section.
2. Enter the Port Number, Physical Address, and IP Address in the
appropriate fields.
3. Click on Set. Status information displays above the command buttons and a
confirmation window opens; if the set succeeded, the new entry appears in
the display panel.
NOTE
When an entry is highlighted the interface description is displayed in the Values for Set
section of the window, (e.g., Ctron SEHI EnetPort).
NOTE
If the Physical Address is entered in an incorrect format, an “Invalid Ethernet
Address” message displays. Enter the address in the correct XX-XX-XX-XX-XX-XX
hexadecimal format. If the IP Address is entered in an incorrect format, an “Invalid IP
Address” message displays. Enter the address in the correct XXX-XXX-XXX-XXX
format.