Installation

INSIDE VERTICAL INSTALLATIONS:

 

 

���� ��� ������� ��� ��

1.

Choose a stove location that is ideal. See the

 

section “DECIDING WHERE TO LOCATE YOUR PELLET

�� ����� ��� ����� ���

 

� ��

APPLIANCE.”

 

���� �� ��� ������ ������

���� ���

 

 

���� ��������

2.

Place a non-combustible hearth pad where

 

necessary.

���� ������

 

3.

Place the unit on the hearth pad (if installed

���� ���� ����

������� ������

 

on a combustible surface) and space the

������� �����

 

unit in a manner so when the pellet vent is

 

 

installed vertically, it will be 3” (7.5 cm) away

 

 

from a combustible wall.

�������� ���� ����

4.

Install the tee with clean out.

5.

Install the pellet vent upward from there.

 

 

 

When you reach the ceiling, make sure

 

 

that the vent goes through the ceiling fire

 

 

stop. Maintain a 3” (7.5 cm) distance to

����� ��� ��� ����

 

combustibles and keep attic insulation away

���� �������

 

from the vent pipe. Maintain an effective

 

 

 

 

vapor barrier.

����� ��� ���� �������� ����

6.

Finally, extend the pellet vent to go through

�������� � ������ ���� ���

 

the roof flashing.

���������� �� �������������

 

 

 

 

7.

Ensure that the rain cap is approximately 24”

Figure 15: Inside Vertical Installation.

(600 mm) above the roof.

 

OUTSIDE VERTICAL INSTALLATIONS:

 

 

To accomplish a outside vertical pipe installation, follow steps 1 through 5 in the “INSIDE VERTICAL

INSTALLATIONS - FREESTANDING” section and then finish it

by performing the following (refer to Figure 16).

Rain cap

Flashing

24"

(61 cm)

1.Install a tee with clean out on the outside of the house.

2.Install PL vent upward from the tee. Make sure that you install support brackets to keep the vent straight and secure.

3.Install ceiling thimble and secure the flashing as you go through the roof.

4.Ensure that the rain cap is approximately 24” (600 mm) above the roof.

4"

(10 cm)

3" (7.5 cm) Clearance

Support bracket

Tee with cleanout

Type "PL"

vent

Figure 16: Outside Vertical Installation.

13

Page 13
Image 13
Enviro 50-1221 technical manual Place a non-combustible hearth pad where