Operating Instructions
HEAT LEVEL and Fans will drop down to the LOW setting for 30 minutes. If the thermostat contacts close within the 30 minutes, the HEAT LEVEL will return to the previous MANUAL setting. If the thermostat contacts remain open, the stove automatically begins its shutdown routine. The stove will
TURNING YOUR PELLET STOVE OFF:
•MANUAL and HI / LOW mode: To turn the unit OFF, simply press the ON / OFF button. This will stop the feed of pellets. The blowers will continue to operate and cool the stove down. When cool enough, the stove will turn off.
•AUTO / OFF mode: To turn the unit OFF, turn the Thermostat down or Timer off.
DO NOT turn unit off during
to smoke escaping from the stove.
SLIDER/DAMPER
THE SLIDER / DAMPER MUST BE SET AT TIME OF INSTALLATION. A Qualified Service Technician
or Installer must set the Slider Damper.
If the fire should happen to go out and the heat output indicator has been set on the lowest setting, the Slider Damper should be pushed in slightly, decreasing the air in the firebox.
If, after long periods of burning, the fire builds up |
| |||
and overflows the burn pot or there is a build up of |
| |||
clinkers, this would be a sign that the pellet quality | Exhaust Channel | |||
is poor, this requires more primary air, the slider |
| |||
damper must be pulled out to compensate. Pulling | Exhaust Fan | |||
the slider damper out gives the fire more air. |
| Housing | ||
|
| |||
The easiest way to make sure that an efficient flame | Slider Damper | |||
| ||||
is achieved is to understand the characteristics of |
| |||
the fire. |
|
|
|
|
• A tall, lazy flame with dark orange tips requires |
| |||
more air – Open slider (pull out) slightly. |
|
| ||
• A | short, | brisk |
| |
flame, | like | a | Figure 6: Slider/Damper Plate in Unit. | |
blowtorch, | has |
| ||
Figure 7: Efficient Flame.
too much air – Close slider (push in) slightly.
•If the flame is in the middle of these two characteristics with a bright yellow/orange, active flame with no black tips then the air is set for proper operation, refer to Figure 7.
The combustion exhaust blower is a variable speed blower controlled by the heat output button. This blower will decrease the vacuum pressure inside the stove, adjusting the air to fuel ratio.
SPECIAL NOTES:
Pellet quality is a major factor in how the Pellet stove will operate. If the pellets have a high moisture content or ash content the fire will be less efficient and has a higher possibility of the fire building up and creating clinkers (hard ash
9
