Installation
Figure 34: Corner brackets for
trim.
4.Plug the wiring harness into the control panel (see Figure 33).
5.Loosen the front hopper lid screws and center the top surround panel under the hopper lid., tighten screws.
6.Insert each side panel anchor bolt through the top panel into the corresponding side panel holes and tighten using a 7/16” wench or socket (refer to Figure 38).
7.Place assembled trim over the surround assembly. On the side trims, there are holes 2” (50 mm) from either end. Use
Figure 35: Two pieces of corner
bracket.
Figure 36: Screw to hold the trim against the surround.
a Phillips screwdriver to place a #8 screw 11⁄4” long in each hole and tighten just enough to keep the trim against the surround. (refer to Figure 36).
REMOVAL:
When maintenance is required on the unit the surround must be removed. Follow steps 4 through 7 in reverse order.
The side panel can remain attached because they swing forward for easy access (refer to Figure 39).
Figure 38: Assembling the Surround
Panel, back view.
Figure 37: Panel placed on unit.
���� ��������� |
����� ��� |
Figure 39: Side surround panel swings forward.
25
